Family run in Pleasant Hill, Oregon since 1976

Monday to Friday, 8am to 4pm rainbowpump@yahoo.com (541) 726-1394
Looking down stone lined dug well shaft submersible pump lane county or

Pump Replacement

Well Pump Replacement in Eugene, OR, From Worn Pumps to Upgrades

Rainbow Pump Co Inc provides well pump replacement in Eugene, OR, swapping worn or undersized pumps for the right new unit, including constant pressure systems. Call (541) 726-1394, Monday to Friday, 8am to 4pm.

Time for a New Pump

Signs It Is Time to Replace Old Well Pump Equipment

Every pump wears out eventually, and the signs usually build over months rather than overnight. When the same system needs one repair after another, or the motor itself has failed, a new pump is often the better use of your money.

  • The motor has burned out or no longer starts at all
  • Repairs keep coming back on the same aging system
  • Output has dropped even though the well still has water
  • Sand or grit has worn the impeller and pressure stays weak
  • The pump was never sized for the household it serves now

A failing pump can also strain the pressure switch, the tank and the wiring around it. Replacing it before it quits completely lets you plan the work instead of losing water without warning. A planned well pump replacement in Eugene, OR also gives you time to weigh upgrade options rather than taking whatever pump fits.

Blue jet pump motor mounted on tank gauge pressure switch cottage grove or

Steps in a Typical Pump Replacement

A replacement is planned around the well that is already there. The goal is a pump that fits the well and the household today, installed so the rest of the system works with it.

  • 1

    Confirm the Diagnosis

    We test the controls, wiring and tank first, so a pump only comes out of the well when the pump is truly the problem.

  • 2

    Choose the New Pump

    We size the replacement to the well and your current demand, and talk through upgrades such as constant pressure control.

  • 3

    Pull the Old Pump

    We lift the old pump, drop pipe and wire out of the casing and inspect each piece for wear that should be replaced too.

  • 4

    Install and Test

    We set the new pump, reconnect the controls, bring the system up to pressure and check its cycling before we leave.

Upgrading to a Constant Pressure Well Pump

A standard pump runs at full speed until the pressure switch shuts it off, so pressure in the house rises and falls between the switch settings. A constant pressure well pump uses a variable speed drive that speeds the motor up or slows it down to hold one steady pressure. Showers stay even, and several taps can run at once without a noticeable drop.

The drive also starts the motor gently instead of all at once, which eases the strain on the pump and wiring. Constant pressure systems often work with a smaller pressure tank than a standard setup, which helps where space in the well house is tight.

The upgrade is not right for every well. The drive is an electronic control that needs a suitable power supply and a protected location, and it adds to the cost of the job. Most constant pressure systems run a submersible well pump, so the replacement pump and the drive are chosen together.

Crawl space sump basin submersible pump white vapor barrier work light oregon

Other Well Pump Upgrade Options to Consider

A replacement is the best moment for a well pump upgrade, because the system is already open and the old pump is already out of the well. Small improvements made now can save a second trip later.

Many households have grown since their pump was installed, adding a bathroom, a garden or animals. Moving to a pump with more capacity, when the well can supply it, brings the system back in line with how the property is used today. Pairing it with a larger pressure tank reduces how often the pump starts.

While the pump is out, it often makes sense to replace a worn drop pipe, old wire or a corroded pitless adapter at the same time. We point out what we see so you can decide what to replace now and what can wait. Homeowners planning a well pump replacement in Eugene, OR often fold these smaller upgrades into the same visit, since the crew and equipment are already on site.

Water holding tank pressure tank pump system pleasant hill

What Drives Well Pump Replacement Cost

Well pump replacement cost depends on the pump you choose and the work needed to reach and reinstall it. A shallow, accessible pump is a different job from a deep submersible pump set far down a narrow casing.

  • How deep the pump is set and how much pipe and wire it hangs on
  • The size and type of the new pump
  • Whether you add a constant pressure drive
  • Whether the pressure tank, switch or wiring also need replacing
  • Access to the wellhead, the well house and the controls

We walk through the options before the work starts, including the difference between a like-for-like swap and an upgrade. Every well pump replacement in Eugene, OR and the nearby towns begins with that conversation, so the choice is yours.

Black holding tank cream pressure tank green pump new home construction springfi

Why Rainbow Pump

Why Choose Rainbow Pump Co Inc to Replace Your Pump

Rainbow Pump Co Inc has replaced water well pumps in this part of Oregon since 1976. The business is owned by the Jones family, who keep up a family tradition of hands-on management on every job.

Our technicians have decades of experience and factory training from top pump manufacturers, which matters when choosing between pump types and control systems. We are licensed with the Oregon Construction Contractors Board, CCB #38493, and we replace residential, commercial and agricultural pumps.

We only recommend a new pump when the old one cannot be saved. If a fix will restore the system, our well pump repair service is the first option we offer. Replacement is one part of the full range of water well pump services we provide.

Threaded metal pipe end water stream close up pleasant hill well pump

Well Pump Replacement in Eugene, OR and the Surrounding Valley

Our shop in Pleasant Hill puts us within reach of homes, farms and businesses across about a 50 mile radius. Many of the wells we work on serve rural properties well outside city water service, where a replacement pump is the only way to keep the household running.

We replace pumps for Eugene well pump service customers in the hills and rural edges around the city, for Springfield well pump service customers out toward Walterville on the McKenzie River, and for neighbors through Pleasant Hill well pump service, between the Coast Fork and the Middle Fork of the Willamette. Each town brings its own mix of well depths and older systems.

Older homes in the valley often still run their original pump and tank, which makes them strong candidates for an upgrade. See every area we serve to check your location.

Pump Replacement Questions

Should I replace the pressure tank when the pump is replaced?

Not always, but it is worth checking. A tank that has lost its air charge or has a failed bladder will make a new pump short cycle and wear out early. If the tank is old or undersized for the new pump, replacing both together protects the investment in the pump and saves a separate visit.

Does a constant pressure well pump need a special pressure tank?

It still needs a pressure tank, but usually a smaller one than a standard system. The tank gives the drive a small buffer so the pump does not start for every brief demand, such as a toilet refill. We size the tank to the drive and the household when we design the replacement.

Can a jet pump be replaced with a submersible pump?

In many cases, yes. A submersible pump can replace an above ground jet pump when the well casing is large enough to hold it and the well is deep enough. The change can improve pressure and reduce noise in the house. We check the casing size and well depth before recommending the switch.

Will a bigger pump give me more water?

Only if the well can supply it. A pump can move water no faster than the well recovers, and an oversized pump can draw the water level down too far. When a household needs more water, we look at the well first, then choose the pump and tank size the well can actually support.

Should the drop pipe and wire be replaced with the pump?

It depends on their condition. When the pump comes out, we inspect the drop pipe, the wire and the splices. Pipe that is cracked or wire with damaged insulation is worth replacing while everything is out of the well, because pulling the pump again later for those parts adds a second job.

Yellow submersible pump beside open green well cover lane county oregon
Excavated pit black well seal blue pipe pitless adapter lane county

Plan Your Replacement

Get a New Pump Matched to Your Well

An aging pump gives you time to choose a replacement on your terms, before it fails on a busy morning. Call Rainbow Pump Co Inc at (541) 726-1394, Monday to Friday, 8am to 4pm, to talk through a like-for-like swap or an upgrade.